LIM@rcgl1.eng.ohio-state.edu (Chin-poh Lim) (08/21/90)
I am thinking of getting AutoCAD ( Release 11 ) for my DECstation
and would like to get some opinion on AutoCAD,
This is what I need in a CAD system......
1) I have a DECstation3100, Ultrix3.0
2) Must have 3D
3) CAD needs to have good wire-frame modeling, able to do fillets... etc.
4) Solid modeling not a must but will not get all too upset if included.
5) Speed ??? ("" Anybody used a AutoCAD on a decstation before ?? "")
6) etc.... Just tell me what you think of AutoCAD on the whole
7) Any other packages better than AutoCAD ( don't need big packages like
CATIA or CADEM... must be small enought ot used is a Workstation )
Any suggestion, opinion or etc....( good or bad ) about AutoCAD please
post or e-mail to ::
internet : lim@rcgl1.ohio-state.edu
thanks in advance....
Jonathan Lim