rr@umree.UUCP (06/21/88)
I am a grad student at UMR and I have been using magic for sometime now.
I intend to use magic for designing a PC bus startup (similar to the
VME bus startup MDF) and I have run into a number of problems.
1. Magic supports nmos, scmos and stdcmos while a number of support
tools support nmos, cmos and cmos-pw. What are the differences
between stdcmos, cmos and cmos-pw ? The cif layer names for
both stdcmos and cmos-pw seem to be the same.
2. The technology file for stdcmos (the version we have) seem to lack
resistance definitions in the extract section. Has anybody got a fix
for that ?
3. The .sim file produced by ext2sim is not being understood by sim2spice.
The header seem to miss "format" column. The sim file produced by
mextra from the cif file of the same design seem to be ok and I am
able to convert it to spice deck without a problem.
I would very much appreciate any help in this regard.
My email addresses:
BITNET: s094299@UMRVMA
UUCP: ...!hplabs!rutgers!mtune!occrsh!umree!ram
Surface: Rajamani Ramasubramanian
Electrical Engineering Dept.
University of Missouri
Rolla, MO 65401