jzubairi@rodan.acs.syr.edu (Junaid Ahmed Zubairi) (12/19/90)
Subject: Problems with new MAGIC command EXTRESIS for accurate resistance
extraction.
(1)I run MAGIC ver 6.3 and it runs.But when I do command
"extract all",and later ext2sim , the .sim file has no R lines although
extractor "do" options include resistance.
(2) I try to
improve resistance extraction with "extresis" command after
I have .sim file [as described in man pages of ver6.3], extresist command
gives warning "FET RESISTANCE IGNORED OR SET TO 0 IN TECHNOLOGY FILE" and
it gives no output.(i.e. .res.ext file has no lines in it.)
[ I have to give additional command :select then it extracts
all resistances to 0.000000 etc.]
(3) I wish to run resistance extractor EXTRESIS with MAGIC -d NULL
option because accurate resistance extraction is part of my software.
If I give :SELECT command in source file for MAGIC and then EXTRESIS, I
think that it will work. Is there an error in this approach?(Note my
design is non-hierarchical)
Thanks a lot
Junaid Zubairi
ECE Dept.
Syracuse Universitydmiller@YODA.EECS.WSU.EDU (12/19/90)
I had a similar problem using ext2sim. The parameter file, scmos2um.prm has "resistance" mis-spelled as "resitance". Try fixing it and see what happens. - --DLM ********************************************************************** David L. Miller Internet: millerd@prime.tricity.wsu.edu (?) Systems Analyst or dmiller@cs2.cs.wsu.edu (reliable) WSU Tri-Cities Bitnet: MILLERD@WSUVM1 100 Sprout Rd. Voice: (509) 375-9245 or 375-3176 Richland, WA 99352 >>>>>>>>>>> Support the FSF <<<<<<<<<<<