ftegerer@faui09.informatik.uni-erlangen.de (Frohwalt Egerer) (06/26/91)
Could someone tell me if my Janus Software is up-to-date? When I reboot the AT it displays the following stuff under the BIOS-box: Janus-Handler 2.63 Janus Library 33.1 I suspect I got some strange sort of software, as I think the highest Janus version is 2.0. (Do I have a 1.63 that was patched by some $#@!&* ?) The software I have leaves 'dead' Intuition-screens, after you quit the PCColor (PCMono) Program. (Yes - the window closes) Besides that thing there are many other Problems with the board, it often doesn`t configure when BindDrivers is executed, sometimes it has a Parity Error and someetimes it doesn't load the Janus Software from the Amiga side. (Just behaves like a normal AT without any Disk mounted to it) My Hardware configuration: ALFII HD Controller Supra RAM Board (6 Meg) Amiga 2000 Rev 4 ECS AmigaOS 1.3 and 2.0 (The board works _slightly_ better under 2.0) Another thing: Today I got an A2630 Turbo Board with 2 Megs RAM - now I got 8 Megs RAM plus the BridgeBoard. The result: out of autoconfig space. Now the question: Is there any way to make the BridgeBoard autoconfig to some other area? I got SO MUCH of free address space, and the BB configs to the area where the mem expansions belong! -- Let your mind go, let your mind go, let your mind go, let your mind go ... Now give me all your money, then count to three and wake up. You`ll remember nothing. Frohwalt Egerer Am Faerberhof 6 W-8520 Erlangen 09131/204791
burkert1@platon.fmi.uni-passau.de (Klaus Burkert) (06/26/91)
In article <ftegerer.677873568@faui09> ftegerer@faui09.informatik.uni-erlangen.de (Frohwalt Egerer) writes: >Could someone tell me if my Janus Software is up-to-date? > >When I reboot the AT it displays the following stuff under the BIOS-box: > >Janus-Handler 2.63 >Janus Library 33.1 That's OK. [...] >My Hardware configuration: > >ALFII HD Controller >Supra RAM Board (6 Meg) >Amiga 2000 Rev 4 >ECS >AmigaOS 1.3 and 2.0 (The board works _slightly_ better under 2.0) > >Another thing: > >Today I got an A2630 Turbo Board with 2 Megs RAM - now I got 8 Megs RAM >plus the BridgeBoard. The result: out of autoconfig space. >Now the question: >Is there any way to make the BridgeBoard autoconfig to some other area? >I got SO MUCH of free address space, and the BB configs to the area >where the mem expansions belong! > No, no way! :-(( You have to remove 2 Meg from Your RAM-Expansion. Ciao, Klaus. ------------------------------------------------------------- Klaus Burkert email: burkert1@platon.fmi.uni-passau.de Brandweg 11 voice: +49-851/83993 D-W-8390 Passau / Federal Republic of Germany