bacon@zeus.unomaha.edu (Infomaniac) (04/21/91)
Imploder3.1 Question
This program is supposed to implode libraries without any ill effects. H
owever, I decided to implode the arp.library and now on bootup I get an error
message that says .... Arb.library v39+ needed (not sure about ver number)
Does anyone know what I could have done wrong?
Also, thanks go to Phil@documail.uucp. He found the Boot1.lzh that I had been
looking for. However, there is one problem with the problem. It does
something to the system timing so that on bootup the system date is:
<unset><unset><unset>. After any warm boots it is the same! (system date is
not preserved). In addition, after running CURE (virus detector and killer) it
frequently reports a "LoadSeg error" and removes the error.
Anyone know what the cause of the problem could be? (BTW - One of my CIA chips
is bad, and it has been all but impossible to find them on the market. Would
that be a cause of trouble?)
Thanks as always for the collective wisdom of the net!! ;)
Russ
comments/suggestions/additions/deletions/obfuscations/indigestions WELCOMED!!!
------------------------------------------------------------------------------
Gee. . . Toto . . . this sure doesn't look like Kansas!
Russ Bacon University of NE at Omaha /// Have you
Flames > Bitnet - Bacon@UNOMA1 /// tried
Dev:Null Internet - Bacon@zeus.unomaha.edu \\\/// an
Yellnet - (402) 554-2293 \XX/ AMIGA??
------------------------------------------------------------------------------
jms@vanth.UUCP (Jim Shaffer) (04/23/91)
In article <13242.28107d54@zeus.unomaha.edu> bacon@zeus.unomaha.edu (Infomaniac) writes: >Imploder3.1 Question > >This program is supposed to implode libraries without any ill effects. H >owever, I decided to implode the arp.library and now on bootup I get an error >message that says .... Arb.library v39+ needed (not sure about ver number) Stupid Question #1: did you have the Library gadget enabled in Imploder? Stupid Question #2: do you have explode.library in libs:? >Also, thanks go to Phil@documail.uucp. He found the Boot1.lzh that I had been >looking for. However, there is one problem with the problem. It does >something to the system timing so that on bootup the system date is: > ><unset><unset><unset>. After any warm boots it is the same! (system date is >not preserved). In addition, after running CURE (virus detector and killer) it >frequently reports a "LoadSeg error" and removes the error. What has most likely happened is that some program has stomped on your clock registers. Do a "setclock reset" then "setclock save". LoadSeg() was most likely modified by the explode.library. If you don't run CURE, do you still have the problem of not getting arp.library loaded? -- * From the disk of: | jms@vanth.uucp | "You know I never knew Jim Shaffer, Jr. | amix.commodore.com!vanth!jms | that it could be so 37 Brook Street | uunet!cbmvax!amix!vanth!jms | strange..." Montgomery, PA 17752 | 72750.2335@compuserve.com | (R.E.M.)