sl2ls@cc.usu.edu (06/04/91)
From : Rajeev Danank June 04, 91Utah State University, Logan, Utah 84322
I have connected a remote workstation to my Novell server using Hayes
compatible Avatex 1200hc external modem on both sides. I can login to the
server once but I cann't login the second time.
server parameters are as follows :
machine : 286 based TeleVideo
NetWare : ELS Level II ( dedicated configuration )
LAN : LAN A - for network board
LAN B - IBM Async COM1/COM2
In ARCONFIG : Modem Type - Hayes compatible
Baud Rate - 1200
Auto Connect - no
ID string - none
workstation parameters are as follows :
machine : 386 based Dell 310, DOS 3.3
In ARCONFIG : Modem Type - Hayes compatible
Baud Rate - 1200
ID string - none
When server is booted up, modem goes to Auto Answer mode and everything
comes up normally. I boot up the workstation and run IPX. The connection gets
established and IPX gets loaded. Then I run NET3.COM and login to the server.
After I logout I switch off the workstation. Now when I boot up my workstation
again, I can load IPX ( which also makes connection ) but when I run NET3.COM
I get the following message :
A Fileserver could not be found.
I have tried different versions of NET3.COM. Also tried specifying PS
( preferred server ) in the command line. Configured workstation as well as
server for the special configuration of modem ( other than Hayes ). None of
these make any difference. Tried getting help from Novell too.
I would appreciate sending any info on this problem to me via E-mail.
Thanks.
Rajeev Danank
Dept. of Electrical Engineering
Utah State University, Logan, Utah 84322
E-mail : sl2ls@cc.usu.edu