hamish@waikato.ac.nz (06/20/91)
I have a PS/2 running netware 2.15C that I would like to put an IBM EDSI disk controller in, as well as the existing Adaptec 1640 SCSI controller. By themselves they each work fine, but when I put them both in the box (A Model 80) the netware will Abend with Cant get disk parameter Individually they work fine, and the PS/2 Ref setup doesn't indicate any conflicts. They are set up as Adaptec 1640 - Slot 8 Option3 (Novell) IO=330h, IRQ=11, DMA=6 and IBM ESDI - Slot 7 Option 0 (Novell) DMA=5 etc... (Default Instalation!) Anyone have any ideas? (Oh by the way, I have tried alternating the disk channels but to no avail) -- ============================================================================== | Hamish Marson <h.marson@waikato.ac.nz> | | Computer Support Person, Computer Science Department | | University of Waikato | |Disclaimer: Anything said in this message is the personal opinion of the | | finger hitting the keyboard & doesn't represent my employers | | opinion in any way. (ie we probably don't agree) | ==============================================================================