fac7@dayton.saic.com (Steven Poling) (04/24/91)
OK.... here's the question of the day.... I have a Windows 3.0 Communcations package I am writing and I need to hang the modem up after the communications session has ended. Using a MultiTech 9600 Baud v.32 modem I get the attention of the modem by sending three plus signs and then an "ATH0<CR>" and the connection is terminated. The problem: When I use a normal 2400 baud modem to make the connection, I still get the modems attention, but when I send the modem the "ATH0<CR>" I get no response from the modem and the line does not hang up. Side light: Does anyone know how to drop DTR on a com port in Windows???? Any help is appreciated very much..... Steven Poling -- _____________________________________________________________________________ ____ ____ ___ Steven Poling /___ /___/ / / Science Applications International Corporation ____// / / /__ Dayton, Ohio ----------------------------------------------------------------------------- Internet: fac7@dayton.saic.com uucp: dayvb!fac7
hans@pine.circa.ufl.edu (Hans van Oostrom) (04/25/91)
In article <1991Apr24.113819.1583@dayton.saic.com>, fac7@dayton.saic.com (Steven Poling) writes... >Side light: Does anyone know how to drop DTR on a com port in Windows???? > Check out the EscapeCommFunction Hans van Oostrom PO Box J-254, JHMHC hans@ufpine (BITNET) Gainesville, FL 32601, USA hans@pine.circa.ufl.edu (INTERNET) >>> Hoe ver je ook gaat, overal zie je landgenoten <<<
stergios@portia.Stanford.EDU (Stergios) (04/26/91)
Can anyone recommend a serial board with, say 8 or so ports, that comes with a windows 3 driver? thanks sm