marcelm@joymrmn.uucp (Marcel Mongeon (Admin)) (01/17/91)
Operating system is SCO Xenix 2.3.3. Serial Board is an Anvil Stallion. Modem is a Telebit Trailblazer Plus. I can't esatblish a uucp connection over a setting of 9600 Baud in the Systems file. When I use 19200, I'll get some transfers but then packets get lost and uucico bombs out. The message from uucico using "-x9" when I get the bomb out after 5 alarm messages indicates : ASSERT ERROR (uucico) pid: 1234 ( 1/16-16:39:45 ) PKXSTART ret (0) [FILE: pk1.c, LINE: 345] A little investigation has shown that my problem seems to be that my uucico program is not using the RTS and CTS signals that it is getting from the modem. When uucico is operating, running stty -a on the modem port shows " -rtsflow " and " -ctsflow " among all of the settings. I know that they should be " rtsflow" and " ctsflow". Anyone have any ideas how I make sure uucico sets the serial port properly. Should I be monkeying around with something in uucico using adb? Up to now, I haven't touched it but am using the uucico and dialTBIT that came out of the SCO box. -- ||| Marcel D. Mongeon ||| e-mail: ... (uunet, maccs)!joymrmn!root or ||| joymrmn!marcelm