jep@pcgbase.UUCP (John E. Phillips) (05/31/91)
Can someone tell me if I need a special version of Xenix to run on
the IBM PS/2 Model 70, or would a standard Xenix (Not GT) run?
I have 4MB of ram and an 80mb Hard disk.
Thanks.
--
John E. Phillips | "The fewer the facts, the stronger the opinion"
P.O. Box 903 | -Arnold H. Glasow
Montreal, PQ H3C 2V8 | E-mail jep@pcgbase.UUCP uunet!pcgbase!jep
| attmail!pcgbase!jep EASYLINK 62852843
exnirad@brolga.cc.uq.oz.au (Nirad Sharma) (05/31/91)
jep@pcgbase.UUCP (John E. Phillips) writes: >Can someone tell me if I need a special version of Xenix to run on >the IBM PS/2 Model 70, or would a standard Xenix (Not GT) run? >I have 4MB of ram and an 80mb Hard disk. I am running Xenix 2.3.2PS on a PS/2 Model 80. Note the PS in the version number. I assume that this catersfor any MCA differences. Otherwise, everything runs fine (software / MCA hardware). My hardware is : IBM PS/2 Model 80 + 4Mb on system board HyperRam 16/32 4Mb HyperPort 3 Serial + 1 Parallel Anvil Stallion 12-port Intelligent Serial Controller Excelan 215T Intelligent Ethernet Card (TCP/IP) Cipher Streaming Tape Controller WD Hard disk controller (used to have IBM's but it was too dumb) 2 HDs -> 110 IBM std ESDI 160 Micropolis ESDI Has been working fine for approx 2 years as an Oracle db engine / app. -- Nirad Sharma (exnirad@brolga.cc.uq.oz.au) Phone : (+61 7) 365 7575 Systems Programmer Fax : (+61 7) 870 5080 Continuing Education Unit The University of Queensland. QLD 4072