newbery@stout.atd.ucar.edu (Santiago Newbery) (04/04/91)
I am trying to add the ODT-NET service to my *existing* SCO ODT 1.0. First of all I ran the [custom] utility which installed the NET software. After the message "Installation of SCO REX Runtime set complete." I am returned to custom's main menu. The question is how do I get to the section on "Configuring the Network Interface" that is detailed in the ODT Installation Guide pp.83-86? The manual seems to assume that ODT-NET is being installed at the same time as the rest of ODT (I hope one can do this later). I am assuming there is a script or set-up utility that can be run independently, but I can't seem to find it. BTW I have done "mkdev wdn" (I am using a WD8003E card) and that installed the ethernet driver w/out problems. Any direct replies / followups would be appreciated. Thanks, +-----------------------------------------------------------------------+ | | | Santiago Newbery <<<<>>>> newbery@stout.atd.ucar.EDU | | Software Engineer Voice: 303-497-8762 | | Surface & Sounding Systems FAX: 303-497-8770 | | Atmospheric Technology Div. | | National Ctr. for Atmospheric Research | | Boulder, CO. | +-----------------------------------------------------------------------+
ralfi@pemcom.pem-stuttgart.de (Ralf U. Holighaus) (04/05/91)
newbery@stout.atd.ucar.edu (Santiago Newbery) writes: >BTW I have done "mkdev wdn" (I am using a WD8003E card) and that >installed the ethernet driver w/out problems. You also have to do a "mkdev tcp". Regards Ralf. -- PEM Programmentwicklungsgesellschaft | Ralf U. Holighaus fuer Microcomputer mbH | Technical Support PO-Box 810165 D-7000 Stuttgart 80 Germany | holighaus@PEM-Stuttgart.de VOICE: x49-711-713045 FAX: x49-711-713047 | ..!unido!pemcom!ralfi