tvf@cci632.cci.com (Tom Frauenhofer) (06/19/91)
I'm having a little problem with AT&T 3.2.2 on my home system. My set-up
is a 16 Mhz 386sx, 4 Meg ram, CGA board, AMI Bios dated 3/90, 40 Meg IDE
Hard disk. What happens is that I occasionally get blank lines on the
display when I scroll down a lot. I believe this is cause by something
called Hardware scrolling. Why I believe this is that I used to run
Minix, and there was a specific section in the document that described
my problem and which function key I could hit so that I would get software
scrolling. I don't think the card is at fault, I used to have the same
problem under Minix with a Hercules compatible monochrome card.
What can I do to correct this problem?
Thanks in advance!
--
Thomas V. Frauenhofer, WA2YYW, tvf@cci.com | SPAM is a register trademark
{uupsi,ccicpg}!cci632!tvf@uunet.uu.net | of a pork product packed
tvf@frau.UUCP | only by Geo. A. Hormel
tvf1477@ma.cs.rit.edu | & Co. Corp.tvf@cci632.cci.com (Tom Frauenhofer) (06/23/91)
In article <1991Jun19.013053.11430@cci632.cci.com> I wrote >Hard disk. What happens is that I occasionally get blank lines on the >display when I scroll down a lot. I believe this is cause by something >called Hardware scrolling. Why I believe this is that I used to run > ... more garbage ... >What can I do to correct this problem? Play around more. Grrr.... It is the card. I had a Tecmar GraphicsMaster. I put it into monochrome mode, got a monochrome monitor, and it works fine. Sorry for the wasted bandwidth. -- Thomas V. Frauenhofer, WA2YYW, tvf@cci.com | SPAM is a register trademark {uupsi,ccicpg}!cci632!tvf@uunet.uu.net | of a pork product packed tvf@frau.UUCP | only by Geo. A. Hormel tvf1477@ma.cs.rit.edu | & Co. Corp.