joe@grce.UUCP (Joseph Nordman) (11/01/90)
Anyone seen this before? Running Merge386 under Unix, I get a device time-out when trying to access the floppy from the DOS environment. The error message is the standard DOS message: Not ready error writing drive A Abort, Retry, Ignore? This can happen on file copies, or on directory listings. Typing 'r' to force a retry always resolves the error, but I may get a number of these time-outs if the transfer is large. Using the floppy under Unix or MS-DOS works fine, so the hardware seems OK. I am running Merge386 v1.3 under Intel UNIX System V/386 Release 3.2 (Bell Technologies). My hardware is a 25MHz 486 prototype motherboard based on the Opti 486/AT chip set. My Floppy adapter is an Everex 2F,2H standard AT board. I have tried changing AT bus parameters, including increasing and decreasing the bus speed (6.3MHz and 12.5MHz), but the symptoms remain the same. Any ideas? --- Joe Nordman, Chief Engineer Phone: 414-644-8700 GENROCO, Inc. Fax: 414-644-6667 205 Kettle Moraine Drive North Telex: 158279420 Slinger, WI 53086 U.S.A. USENET email: {ames, rutgers, harvard}!uwvax!astroatc!nicmad!grce!joe