rdt154k@monu6.cc.monash.edu.au (mr n benci) (10/22/90)
Maybe some one out there can help me on this. How do these STDMA to SCSI adapter boards really work. I have seen a few and it all looks so trivial but without any info on the ST DMA port I cannot work out how its all done. The best that I have seen so far are the BMS200 which really does seem to support the full (well almost) SCSI (I) command set and the new ICD adapter which is so small, you plug it onto the back of a SCSI drive. These two boards don't have all that much on board. So if its legally possible to disclose such info (which iI think it is) could some kind soul kindly enlighten me as to what is actually done. I would like to try it as a hardware project and hopefully get somewhere. Thanks in advance. ------------------------------------------------------------------------------ * Nino Benci. * Confucious say * * Monash University, Caulfield Campus * 'Never stand alone against * * Physics Department * against ignorance' * * 900 Dandenong Rd, Caulfield East * * * VIC, 3145. Tel (03) 573 2355/2519 * * * Australia * * * email oz: rdt154k@monu6.cc.monash.oz.au * * email world: rdt154k%monu6.cc.monash.edu.au@uunet.uu.net * ------------------------------------------------------------------------------