ekrimen@ecst.csuchico.edu (Ed Krimen) (12/06/90)
I should have known an address like this one wasn't going to work.
Since the e-mail went boing-boing, I'll post it here.
Date: Wed, 5 Dec 90 15:23:58 pst
Return-Path: <MAILER-DAEMON@cscihp.ecst.csuchico.edu>
Subject: Returned mail: Host unknown
To: ekrimen@cscihp.ecst.csuchico.edu
----- Transcript of session follows -----
550 mcli@joker... Host unknown
----- Unsent message follows -----
Received: by cscihp.ecst.csuchico.edu
(15.11/15.6.R1) id AA09343; Wed, 5 Dec 90 15:23:58 pst
Date: Wed, 5 Dec 90 15:23:58 pst
From: Ed Krimen <ekrimen@cscihp.ecst.csuchico.edu>
Return-Path: <ekrimen@cscihp.ecst.csuchico.edu>
To: mcli@joker
Subject: Re: Disk Drive Problem
Newsgroups: comp.sys.atari.st.tech
In-Reply-To: <10805@ur-cc.UUCP>
Organization: California State University, Chico
Cc:
- So, I ran a drive speed program to see what the speed of the drive
- is. It was something like 304.56rpm. As I recall, the speed
- should be around 300rpm. Could this be my problem?
This could be your problem.
- If the only solution is to replace the drive, I would like to find
- out which drive mechanisms work the best, and where to get them.
- Are there any other solutions?
I've never looked at a floppy drive mech that well, but I hear that
there should be a pot on some that allow you to adjust the speed of
the drive. Try this first. (Also, if possible, try the disks on
another ST.) Ask the net for info about adjusting the drive speed.
--
Ed Krimen ...............................................
||| Video Production Major, California State University, Chico
||| INTERNET: ekrimen@ecst.csuchico.edu FREENET: al661
/ | \ SysOp, Fuji BBS: 916-894-1261 FIDONET: 1:119/4.0