andrewsh@lonex.radc.af.mil (Harold G. Andrews II) (02/20/91)
Hey gang...
I have an NEC MGE 256 board installed on a ZEOS 486/25 EISA machine.
Thus far, I have been unable to tap the full potential of the board (I have
drivers for Windows 3.0 and a few other pieces of commercially available
software). I have contacted GSS, the people who wrote the DGIS front end
for the drivers. I have also contacted Texas Instruments concerning their
TIGA support. My question is this: Are there any other companies out there
selling software to make use of the TMS34010? Namely, are there any other
third party assemblers, compilers, etc. so that I can directly access the
TMS34010 chip without going through the DGIS front end?
Please e-mail me, and if there is interest in the results, I will post
them. Thanks.
-Andy
*******************************************************************************
* Harold G. "Andy" Andrews II, 1Lt, USAF * "Many the man whose punctuality *
* andrewsh@lonex.radc.af.mil * serves only to warm his chair." *
* Rome Laboratory/IRRE * *
* Griffiss AFB, NY 13441-5700 * - M. Kabrisky *
* (315) 330-7788 (AVN Prfx 587) * (Not an official USAF viewpoint) *
*******************************************************************************