nan@matt.ksu.ksu.edu (Nan Zou) (03/20/91)
Could anyone recommend a good source for learning IBM assembly programming?
I'm a beginner in assembly. Appreciate any info.
--
Nan Zou | Bitnet : nan@ksuvm
Kansas State University | Internet: nan@math.ksu.edu
#include <std_disclaimer.h> | nan@matt.ksu.ksu.eduldstern@rodan.acs.syr.edu (Larry Stern) (03/21/91)
In article <1991Mar20.065413.27800@maverick.ksu.ksu.edu> nan@matt.ksu.ksu.edu (Nan Zou) writes: >Could anyone recommend a good source for learning IBM assembly programming? >I'm a beginner in assembly. Appreciate any info. > >-- > Nan Zou | Bitnet : nan@ksuvm > Kansas State University | Internet: nan@math.ksu.edu > #include <std_disclaimer.h> | nan@matt.ksu.ksu.edu I would recommend "Peter Norton's Assembly Language Book for the IBM PC" by Peter Norton and John Socha (Brady Books, 1989), a very good tutorial-type book that takes you from 'debug' to modular design. It also comes with a companion disk with lots of assembly line programs covered in the book. P.S. you *will* need an assembler. Larry Stern LDSTERN@RODAN.ACS.SYR.EDU
elund@graphics.rent.com (Eric W. Lund - Subop) (03/21/91)
nan@matt.ksu.ksu.edu (Nan Zou) writes: > Could anyone recommend a good source for learning IBM assembly programming? > I'm a beginner in assembly. Appreciate any info. I found Peter Norton's Assembly Language Book for the IBM PC to be a great place to begin. It starts out by having you write some short routines in DEBUG, so it gives you a very good feel of what goes on the insides. Halfway thru it starts talking about assemblers and you follow them step by step as they build a disk sector editor in assembly language. It's a pretty good book -- I recommend it.