mfontana@eniac.seas.upenn.edu (Mark A Fontana) (04/15/91)
I just installed QEMM-386 5.12 and Desqview 2.32 on my 386 clone, and I'm having two weird problems: 1) When I run Manifest under Desqview, if I select either of the "Timings" functions, the table never comes up, it just keeps timing and timing, or else locks the machine up. I found no way to exit this. If I run Manifest outside of Desqview, it works fine. 2) I'm using MSDOS 3.30, and my CONFIG.SYS file looks like this: files=30 stacks=0,0 buffers=1 device=c:\dos\ramdrive.sys 1000 512 /e DEVICE=C:\DV\QEMM\QEMM386.SYS ON NOVIDEOFILL RAM ADAPTERROM=C000-C7FF device=c:\dv\qemm\loadhi.sys /r:2 c:\mouse\mouse.sys device=c:\dv\qemm\loadhi.sys /r:2 c:\dos\ansi.sys device=c:\dv\qemm\loadhi.sys /r:2 e:\windows\smartdrv.sys 512 512 First of all, are there any obvious problems here? I notice that if I include the RAMDRIVE.SYS, then when I run Manifest to check memory timings, the PC/XT indexes are all about 0.2. But if I don't use RAMDRIVE.SYS, then the PC/XT indexes are around 12.4. Nevertheless, Desqview itself seems to run okay either way. What is going on here? - Mark .-----------------------------------------------------------------------------. | Mark A. Fontana (215)573-8410 | ACCOMPANYING, ANIMATION, PROGRAMMING, DALs | | mfontana@eniac.seas.upenn.edu | Rhymes, fine rhymes, sweet rhymes have I... | `-----------------------------------------------------------------------------'