rohr@uklirb.informatik.uni-kl.de (Michael Rohr Dfki) (08/15/90)
Hi, because I was running low of disk storage place I recently installed a Western Digital RLL-controller (1:1 interleave). But since then my computer does not boot at 12 mhz. It only boots when it is running at 6 mhz. After booting I'm able to switch over to 12 mhz and everything works fine then. Usually the computer passes the memory test, tries to access drive a, checks drive b. While the lamp of drive b still flashes the computer tries to access c. The hard drive's lamp flashes shortly and then everything stops. Only the drive lamp of b is still burning. The only thing I can do then is to reboot via hardware reset. I'm also able to get into the setup routines. The computer I'm using is a MAGIX Competition (12 mhz NEAT). It has 2 mb ram, INTEL coprocessor, ATI WONDER VGA (256 kb and bus mouse, BIOS V3M-1.06), 3.5 1.4 mb and 360 kb 5.25 disk drive, MITSUBISHI MR535 hard drive. Shadow ram as well as EMS is enabled. BIOS is made by DTK (NEAT BIOS ver. 3.25 03/17/89). Any ideas and thanks in advance? Jens rohr@informatik.uni-kl.de until 10th of Sept. boelte@dmrhrz11.bitnet from 13th of Sept. p.s. you may wonder why the signature and the address in the header don't correspond. Right now I'm using a friend's account and I can be reached under his address till the 10th of september. After that I can be reached under my own address which is: boelte@dmrhrz11.bitnet.