AVP100@psuvm.psu.edu (02/01/91)
Hi,
I have a DTK 2503 386/25 running with a WD1006 HD/FD controller and a ST01/1
6k BIOS SCSI controller. The controller BIOS is 3.1.9 and it came with my Syqu
est 44Mb removable drive. The problem I'm having is that old programs such as
games or even newer programs using a non-Dos booting scheme causes m system to
error and go to the 'Hit F1 to continue or run SETUP' msg. The system refuses
to boot any of these programs at all. When I pull the ST01 card, all the progr
ams operate normally. It seems the ST01 bios is conflicting with the SCSI bios
on the ST01 card. BTW, I also tried removing the SCSI driver from my config
file, but the programs don't work that way either. Any ideas on the problem?
Thanks
A.P.
AVP100 at psuvmparke@star.enet.dec.com (Bill Parke) (02/07/91)
I have an ST02 so... Look in the Segate book that came with the ST01 (I hope). It will tell you how to change the BIOS address to one of 4. There is the default (C000??) and 3 others settable by a jumper block. I know my future domain board is set to the highest of these so as not to conflist with the other things in my 386. -- Bill Parke VMS Development decwrl!star.enet.dec.com!parke Digital Equipment Corp parke@star.enet.dec.com 110 Spit Brook Road ZK01-1/F22, Nashua NH 03063 The views expressed are my own.