sonny@charybdis.harris-atd.com (Bob Davis) (03/02/91)
On a Tandon TM100-4 360K Full Height floppy, there is an empty 16-pin IC socket near the cable connector which I presume must be programmed with jumpers to do the appropriate Disk Select for Drive A: or Drive B: as desired. This socket is NOT for the terminating resistors -- I see a T-RES pack at another spot on the circuit board. However, there are no markings near the empty IC socket to give the uninitiated a clue as to how to choose Disk Select x. If you know secrets about this IC socket, I would be grateful to hear them. Thanks. _____________________________________________________________________________ Bob Davis, UofALA alum \\ INTERNET: sonny@trantor.harris-atd.com | _ _ | Harris Corporation, ESS \\ UUCP: ...!uunet!x102a!trantor!sonny |_| |_| | | Advanced Technology Dept.\\ AETHER: K4VNO |==============|_/\/\/\|_| PO Box 37, MS 3A/1912 \\ VOICE: (407) 727-5886 | I SPEAK ONLY | |_| |_| | Melbourne, FL 32902 \\ FAX: (407) 729-3363 | FOR MYSELF. |_________|