chchoi@eng.auburn.edu (Cheong Hyeon Choi) (04/16/91)
Hi, there. I got a trouble to connect the optional LED wire to ST-11R controller. I have successfully installed ST-11R h/d controller in my IBM-XT clone, but I couldn't locate the jumper for the optional LED wire. ST-11R has three jumpers only, so I have tried all the jumpers for the LED wire (for indicator of h/d's read/write). But all combunations do not work. I don't understand this problem because obviously this ST-11R is supposed to have the jumper for optional LED wire. Also I tried to get the manual but I can't. Please help me. If you know BBS number of Seagate or location the jumper for the LED, please let me share your valuable information. Thank you in advance.
reagan@eniac.seas.upenn.edu (Matthew T Reagan) (04/17/91)
In article <chchoi.910415222743@banana.eng.auburn.edu> chchoi@eng.auburn.edu (Cheong Hyeon Choi) writes: > > I got a trouble to connect the optional LED wire to ST-11R controller. > I have successfully installed ST-11R h/d controller in my IBM-XT clone, > but I couldn't locate the jumper for the optional LED wire. ST-11R has ... I'm also using the ST-11R controller (with an ST-124 drive) and I also have found no jumpers--mainly because they are located on the drive itself! Whether this applies to the particular drive you have I can't say, but check. By the way, does anyone know where I could purchase such an extension LED? My 'homemade' extension is rather crude. /------------------------------------------------------------------------\ |Matthew Reagan, ChE'94 |reagan@eniac.seas.upenn.edu| |Box 0587, 3700 Spruce St. \---------------------------| |Philadelphia, PA 19104-6011 | "Knowledge is power, | |University of Pennsylvania, SEAS | but ignorance is bliss" | |(215) 573-6274 \--------------------------| \------------------------------------------------------------------------/