dlb25@LOCAL.UUCP (Dave Besselievre) (04/30/91)
I have purchased a Praim 738 Disk drive (330MB) to use on a Future Domain TMC-885 SCSI controller. There was no documentation with the drive. Can anyone please tell me what the jumper seting on the drive are. The bottom of the drive has three jumpers. W6 was jumpper when received w5 not connected W4 No jumper pins (not connected) W3 Near terminator resistor pack (not installed) resistor pack also not installed. W1 no jumper pins (not installed) 10 jumper pairs next to SCSI connector. scsi connector . . . . . . . . . . . . . . . . . . . . ^ |---| | SCSI adr. ---Motor control ? The motor control jumper seem to be the correct definition for the fourth set of pins, since if jumper the motor spins up on power up. Can anyone provide further details on the pins or better yet know the correct jumper setting for this controller. Thank you for you help. _________________________________________________ | ____ ___ ____| | | / \ __ \ / | David L. Besselievre | || / |\ ___| Chemical Abstracts Service | || | | | Columbus, OH 43210 | || | | | | | \ ____ \____/|\____| osu-cis!chemabs!dlb25 | | | dlb25@cas.bitnet | ------------------------------------------------- _________________________________________________ | ____ ___ ____| | | / \ __ \ / | David L. Besselievre | || / |\ ___| Chemical Abstracts Service | || | | | Columbus, OH 43210 | || | | | | | \ ____ \____/|\____| osu-cis!chemabs!dlb25 | | | dlb25@cas.bitnet | -------------------------------------------------