riddle@mathcs.emory.edu (Larry Riddle) (11/04/90)
Does anyone know what would cause VersaTerm to put up
the alert message: "Sorry...not enough memory to fully
complete this operation."? I am trying to track down why
I get this alert (it is alert ID 299 in VersaTem 4.0). It
always comes up when I try to choose a menu item, but not
under predictable conditions. After clicking the OK button in
the alert dialog box, VersaTerm will quit, but I can immediately
restart it (the phone connection will not have been cut) and
access that same menu item without any immediate complaints (I
may get the same alert again later in the session).
This occurs while running multifinder. I have allocated 500K
to VersaTerm and my SE has 4 megs. I am using a Mobius one page
display monitor with the 16 MHz accelerator that comes with the
display.
On a related note, does anyone know if Lonnie Abelbeck can be
contacted either via the Internet or CompuServe (and if so, what
his address would be)?
Thank you.
--
Larry Riddle | riddle@mathcs.emory.edu PREFERRED
Agnes Scott College | {decvax,gatech}!emory!riddle UUCP
Dept of Math | riddle@emory.bitnet NON-DOMAIN BITNET
Decatur, GA 30030 | (404) 371-6222 AT&T