douglas@sol1.lrsm.upenn.edu (Doug Rodenberger) (04/04/91)
I have installed a Nuvotech Nuvolink SC on the SCSI port of a Mac Plus. All programs work (NCSA Telnet, MacTCP, Broadcast, Public Folder, etc.) with one problem: I want to set the Appletalk Zone, using the Network cdev, but when clicking the Ethertalk (phase2) icon, an error message appears: "You cannot choose a zone at this time because no internet router is available." I know this should work since I have tested a MacIIci with an EtherWorks II card at the same connection, and there are about 10 zones to choose from. In particular, the zones are mainly Gatorboxes which serve appletalk nets on the university's ethernet (phase 2), and I want to be listed on one of them. Any suggestions from people with experience with this would be appreciated. Please send responses to my e-mail address: douglas@sol1.lrsm.upenn.edu and I will summarize on the netnews. Thanks, Doug. ------------------------ D. Rodenberger Physics Department, Univ. of Penna. douglas@SOL1.LRSM.UPENN.EDU