bmug@garnet.berkeley.edu (BMUG) (08/22/90)
This question's probably been asked a million times already,
but here goes:
Is there any way to change the default page sizes in the
Apple Laserwriter 6.x driver?
We're trying to print a FrameMaker/Mac document to a Lino 300
printer. We want crop marks, but apparently there's no way
to get them without specifying Tabloid size in Page Setup.
This leads to an egregious waste of paper. However, if we
were able to specify a paper size of, oh, say 9.5" x 13",
I think we'd be all set. At a savings of 4" per page, for
over 100 pages, it's easy to see how much waste we could
prevent.
Please reply by email or post to the net; I'll summarize
any email replies I get if interest warrants.
Thanks!
John Heckendorn
/\
BMUG ARPA: bmug@garnet.berkeley.EDU A__A
1442A Walnut St., #62 BITNET: bmug@ucbgarne |()|
Berkeley, CA 94709 Phone: (415) 549-2684 | |