ralls@cisco.com (08/17/90)
>I noticed a problem in the Novell routing table here today -- at least >it seems like a problem. I was routing novell between two ethernet >interfaces and wanted to move one of the ethernets to another port. I >pulled the cable and moved it to the other port, then used config to >shutdown the first port and configure the second. I waited for >routing to stabilize and then did a 'show novell route'. All the old >routes were there for the shut down interface and none of the new >routes replaced them. I dissabled novell routing completely, thinking >that would flush the routing table. Upon enabling novell routing >again, the same set of bad routes the to shutdown interface remained. >The only way to clear the routing table was to reboot the cisco. > >Is this a bug or a procedural problem on my part? > >Dave. Learned routes will age out it takes 240 or so seconds. In pre-8.2 there are only to ways two get rid of static/connected routes remove each expilictly (no novell ect..) or turn off routing and reboot the box. In 8.2 static and connected routes will be removed if the interface they are using goes down and stays down. You will have to reenter any static routes you had to make this change. - -vicki