dickson@sal-sun6.usc.edu (Jeffrey Dickson) (09/14/90)
In article 5314 of comp.sys.apple2, gminette@polyslo.CalPoly.EDU writes: >I've been having an irritating problem with trying to print out documents >in any GS DeskTop program. >When I try to print out a multi-page file using Better text or Better Color, >it prints out the first two pages fine, but getting to the third, it starts >to print out a solid black bar on the page, and will keep printing it out >following the basic left right and paragraph margins for the rest of the >document. I've tried to use different printer drivers for my ImageWriter, >but the problem STILL occurs. The draft mode works just fine, though. >I have the ImageWriter.CL printer driver on a GS rom1 with 1.75 Meg mem, >a SCSI Hard Drive with 80meg, running GS/OS version 5.02 I had the same problem today, but in a slightly different way. I had an eight page AWGS page layout document I wanted to put into a PostScript file for later printing on the school's LaserWriters. I followed my usual procedure and the familiar alert box with "Creating PostScript File..." appeared. After "printing" the first two pages, I got the message "The document could not be printed." I finally finished my project by specifing the print job in two page increments but this was a big pain. It's been five months since I've tried to print a 3+ page document on my dot matrix and now I'm almost afraid to try; although it's worked perfectly until now. The only modifications to my system since the last time I printed a long document were the addition of an Ingenuity 2MB board, and AppleWorks GS 1.0 with the ImageWriter.CL driver. Any help from Apple out there? }}} Jeff {{{ dickson@chaph.usc.edu