bdo8650@cec_ss3.wustl.edu (...Dude Guy...) (04/04/91)
I just compiled Tex 3.0 on a Decstation 3100 (Ultrix 4.0). Everything
seems to work fine. The only problem that I have run into is a file
that works perfectly on 2.991 but formats in-correctly on 3.0
(Bear with me, its nothing fancy, I am just learning TeX.)
Here is the latex document: (well part of it, anyway...)
---begin---
\documentstyle{article}
%...title stuff delete...
\begin{document}
\subsection{BJT}
\begin{enumerate}
\item The construction of the load lines are shown on the accompanying
blowup of the {\em polaroid\/} taken of the transistor curve tracer.
The markings were created using pencil, so they are quite hard to
distinguish. The $Q$ point was determined using the {\em midpoint biasing\/}
technique. $V_{CEQ}$ and $I_{CQ}$ are determined by reading the
corresponding $V_{CE}$ and $I_{C}$ value from the curve tracer output.
$I_{BQ}$ can be determined by interpolating between the two nearest
$I_{B}$ values.
\end{enumerate}
\end{document}
---end---
It will LaTeX correctly, and create a DVI file with no errors.
But printing it out/XDvi-ing reveals that it stops at the first $Q$.
Any ideas?
The TeX 2.991 version correctly formats the correct document.
Respond by E-Mail, no need to clutter the net with a silly
problem.
THANKS.
Bryan D. O'Connor bryan@frontier.wustl.edu
Computer Engineering 6718 Delor Street
Office of the Network Coordinator Saint Louis, MO 63109
Washington University in Saint Louis 38 37 38 N / 90 11 52 W