liu@fornax.UUCP (Lixin Liu) (04/23/91)
Hi, I have a few questions about dviscr from emTeX, hope someone could answer
them.
1. What is the limit of dviscr?
I have been trying to display the graphics (both 2D and 3D) generated by
using epic or eepic macros, emTeX works fine; however, dviscr did not
display the graphics correctly, what happen was most of lines in the
graphics disappear.
2. I have used poorman Chinese and Japanese macros and fonts with emTeX.
I have to use btex.exe to make it works. When I try to display the article,
I got the error 2100:DVI file corrupted (undefined font). Same DVI file
displayed correctly on SUN 4 using xdvi. At beginning I thought this is
because dviscr running out of memory. So I decide to display only two
characters. The DVI file generated by btex correctly displayed by dviscr,
but error 2100 happened again when I use blatex.exe (dvips produced a
correct postscript file).
Lixin
liu@cs.sfu.ca
--------------------------------------------------------------------
mail: Lixin Liu, Department of Mathematics and Statistics,
Simon Fraser University, Burnaby, B.C., CANADA V5A 1S6
e-mail: liu@cs.sfu.ca OR Lixin_Liu@sfu.bitnet
phone: (604) 291-3805 (office), (604) 931-6512 (home)
--------------------------------------------------------------------