wayne@gfx.cpsc.ucalgary.ca (Wayne McCormick) (04/18/91)
I have an Adaptec 4070 (SCSI->RLL) that I would *dearly* love to make work with
my 1542B. I got the two hooked up, put my 65 Mb RLL drive on the 4070, and it
wouldn't find it (the drive). Blindly trusting that it was because the drive
had been formatted on another controller (true; an Adaptec 2372C), I used the
debug-accessed formatter in the 1542B. It gave the drive a low-level format,
but it only formatted it to be 6 Mb :-(.
A few questions pop to mind:
o can a 4070 be used with a 1542B?
o how do you format a drive to max capacity with said arrangement?
o when I try to run scsicntl.exe (posted here), it freaks out and says something
about 'sense error' and calmly exits back to MS-DOS.
o why do aspidisk.sys and aspi4dos.sys both say that no SCSI device is
attached?
The drive and the controller are both functional; I had them hooked up to an
Atari ST and checked that out. The software I used on the Atari even knew that
it was a 4070!
Any ideas? Any and all help would be appreciated; I can't afford to get
another drive for a little while and I need some space for a course I am taking
this summer.
BTW: Please reply (if possible) to the mail address below; I am using someone
else's account for this post. Better yet, post your response.
Mike Hoffos
--
Email: mhoffos@janus.mtroyal.ab.ca <- works for most sites. If not, try
just replying to this message
Disclaimer: I don't speak for Mount Royal College, and it don't speak for me.
"Ignorance and prejuduce and fear walk hand in hand ..." Rush/Witchhunt