Harvey_Taylor@mindlink.bc.ca (Harvey Taylor) (05/11/91)
Well at long & dear last, my Teac Scsi Floppy arrived.
It seems that I have a different version of the TEAC FDH-235JS SCSI
floppy than the hardware spec (both JS & HS) . What I want to do is
put it in auto density sense as mentioned in the SCSA driver Readme
(see below).
The problem is that there is a new row of shorting blocks which are
undocumented. These are at the back beside the power connector & are
labelled from front to back:
AC AE IR RY D2 D1 D0
: The factory config was AE & D0 shorted.
So, does anybody know the blocks to set for auto density sense mode
on the 235JS?
Does anybody know what all the blocks configure? There are the User
settable blocks, as well:
EJC J H G F LEV HDS STL
: PAR, MON are the only two documented in the
hardware specification.
And finally, has anybody got a copy of the "FC-1-01 Software
Specification" out of Teac?
-het
PS.
Jonathan Hue maintains the SCSA mailing list. Here is a clip:
|Re:The Sun Common SCSI Architecture mailing list. Send your subscription
|request to scsa-request@island.com, submissions to scsa@island.com. There
|are people there who can answer your questions. There's even a complete
|SCSA driver in the archives to control a TEAC SCSI floppy.
"DOS ... is still a real mode only non-reentrant
interrupt handler, and always will be." - Russell William
Harvey Taylor Meta Media Productions
uunet!van-bc!rsoft!mindlink!Harvey_Taylor
a186@mindlink.bc.ca