griff@anvil.hf.intel.com (03/01/91)
Ok, I'm not sure this will work. I'd like to hook up a NEC 3d to
my 2000 - and from looking at pin-outs this looks like the adaptor
I'll need - Can anybody tell me if this will work?
(NEC 3d - Mode: ON)
High Density 15 Pin Female (NEC) 23 pin female (Amiga 2000)
Pin Pin
red vid 1 ---------------------------+ N/C - 1 xclock
green vid 2 -------------------------+ | N/C - 2 xclcken
blue vid 3 ----------------------+ | +------------3 ana. red
ground 4 -------------------+ +--|--------------4 ana. blue
ground 5 ----------------+ | +--------------5 ana. green
red gnd 6 ------------+ | | N/C - 6 dgtl intensity
green gnd 7 ------------+ | | N/C - 7 dgtl blue
blue gnd 8 ------------+ | | N/C - 8 dgtl green
N/C 9 - N/C | | | N/C - 9 dgtl red
ground 10 ----------+ | | | N/C - 10 Composite Sync
ground 11 ----------+ | | | +-----------11 H sync
N/C 12 | | | | | +--------12 V sync
H sync 13 ----------|-|---|--|-------+ | 13 GndRtn for xclck
V sync 14 ----------|-|---|--|----------+ 14 zero detect
N/C 15 | | | | 15 Clock out
| | | +-------------------16 ground
| | +----------------------17 ground
| +--------------------------18 ground
+----------------------------19 ground
N/C - 20 ground
N/C - 21 -12V power
N/C - 22 +12V power
N/C - 23 +5V power
Thanx in advance -
--
:Richard E. Griffith, "griff" : iNTEL, Hillsboro Ore.
:griff@anvil.hf.intel.com
:SCA!: Cyrus Hammerhand, Household of the Golden Wolf, Dragons' Mist, An Tir
:These are MY opinions, if iNTEL wanted them, They'd pay for `em!rmm20@ccc.amdahl.com (Robert Mitchell) (03/04/91)
In article <1991Feb28.175334.27681@intelhf.hf.intel.com> griff@anvil.hf.intel.com writes: > >Ok, I'm not sure this will work. I'd like to hook up a NEC 3d to >my 2000 - and from looking at pin-outs this looks like the adaptor >I'll need - Can anybody tell me if this will work? > > red vid 1 ---------------------------+ N/C - 1 xclock > green vid 2 -------------------------+ | N/C - 2 xclcken etc. Except for some variation in grounds, this is the pinout I used, and it works fine. I picked up one of the 15 pin to 25 pin RS232 adapter shells (about two inches long), and did all the cross-wiring in that. Of course, the 23 pin connector is a little loose, but it works fine. When (not if) you get your A2320 display enhancer, you can toss the adapter. The NEC 3D will connect directly to the 2320. The display enhancer is the reason I purchased the NEC, and they work great together. - Robert Mitchell -- UUCP: rmm20@juts.ccc.amdahl.com DDD: 408-746-8491 USPS: Amdahl Corp. M/S 205, 1250 E. Arques Av, Sunnyvale, CA 94086 BIX: bobmitchell