eretherf@mcs.kent.edu (Eric Von Retherford) (04/23/91)
I put a 1meg agnus in my machine and find that some things come out totally bogus when run in PAL and NTSC modes!! AHHHHH!! The (de)instructions that came with the chip told me to make to cuts... so I did. I really don't know why I had to do them but I think it was for 1 meg of chip ram. Anyway, my question is...If I were to install two on/off switches to these two cuts and reset the machine would that return my machine to normal??(The way it was when I had the old agnus in it). Bonus question: Can I install a switch that will allow me to use pal mode on startup without the use of software?? If possible reply by email because our reader is always going up and down. Thanks for your time and effort Eric Retherford .