eretherf@mcs.kent.edu (Eric Von Retherford) (04/26/91)
Hello all, I put the new 1Meg agnus in my machine and made the cuts on the motherboard so that I can use 1meg of chip ram and pal. Since I did this some programs do not display the correct graphics in either NTSC or PAL. My question is can I install switches where I made these cuts to restore the back to the way it was? Does anyone know what the two cuts did to my machine? I realize that the cut by the trap door ram probably gave me the ability for the 1meg of ram but what is the other cut for? Is there anyway to install a hardware switch that will let me boot up in PAL without using software? If you can help me please use Email because our reader has been flakey. (I will be amazed if this reaches the masses) Thanks! Eric Retherford