connyo@nfnsun (conny ohstrom nfn9 +46 752 63012) (05/07/91)
I have a sun mouse model M4, and I am trying to make it work with my A2000 ...
but there are some problems. Only 3 wires are going in the cable, +5v/GND/X
'X' is a combined signal for ALL events UP/DOWN/LEFT/RIGHT/BUTTONS ...
Now I wonder if there is someone who already have written such driver ?
--- Do at your own risk ---
If the model is M3 then you can use a more direct method (SP?) to interface it
^^
to the amiga:
1) open the mouse, take care of the plastic balls dont falls out...
2) look at the board, you can see a row of ten (10) soldered holes,
numbered 1-10, these should be soldered as below:
10 pin: 1
\ /
SUN: O O O O O O O O O O
| | | | | | | | | |
| | | | | | | | | |
| | | | | | | | | |
AMIGA: 2 7 8 4 3 1 6 5 9
pin ten(10) is not used...
NOTE: the M3 mouse could also be connected with a 3wire coord, but then you
have the driver ...
exit 0 ; ---
Conny Ohstrom,Televerket nynashamn nfn6, industriv{gen 4, s-149 80 nynashamn
(sweden) usenet: connyo@nfnsun.n.tvt.se, phone: +46 752 63012
--
exit 0 ; ---
Conny Ohstrom,Televerket nynashamn nfn6, industriv{gen 4, s-149 80 nynashamn
(sweden) usenet: connyo@nfnsun.n.tvt.se, phone: +46 752 63012