WOOGIE@UFPINE.BITNET (02/03/90)
We have several Zenith 16 Mhz 386's with their 4-meg memory boards. (1 Meg base, 3 megs extended/expanded depending on the switch settings) The problem is that we cannot access the extra memory at all when we load the Netware workstation software. If we set the switch settings for expanded memory and use the Zenith emm.sys, the machine locks up when we try to load any program that accesses expanded memory. The same is true when we try setting it for extended and using qemm.sys from Desqview 386. (There all are all sorts of parameters needed to get it to work on the Zenith at all.) We are using the packet drivers, but the problem also occurs when we use ipx for the board (we use WD8003e's). Has anyone out there been able to get some use out of this memory? Mike Wohlgemuth University of Florida
WCOWART@UGA.BITNET (Butch Cowart) (02/05/90)
Have you tried excluding part of the memory (640K - 1MB) where your NIC driver resides? You can do this using QEMM. Butch Cowart Information Analyst UGA Health Service