[comp.sys.mac.hardware] what TORQX is needed to open a Mac SE?

hunter@oakhill.UUCP (Hunter Scales) (01/12/90)

Subject says it all.  I need to open my SE to add RAM.

thanks,

-- 
Motorola Semiconductor Inc.                Hunter Scales
Austin, Texas             {harvard,utah-cs,gatech}!cs.utexas.edu!oakhill!hunter
#include <disclaimer.h>

cyamamot@aludra.usc.edu (Cliff Yamamoto) (01/12/90)

In article <2816@cerberus.oakhill.UUCP> hunter@oakhill.UUCP (Hunter Scales) writes:
>Subject says it all.  I need to open my SE to add RAM.

Ahh, I had just asked this a couple months ago to sci.electronics.
You need a T-15 Torx driver at least 8" long (to get the top two screws).
If you need addresses, I've got my past articles/email saved.  Let me know.

Cliff

P.S.  Don't forget to clip/remove the 150 ohm "256K RAM" resistor if you're
      adding 1 Mb SIMMS.