fadushin@rodan.acs.syr.edu (Phred Dushin) (08/20/90)
While unscrewing the scsi cable from my LaCie 30mg Cirrus drive, I inadvertantly removed one of the screws that holds in the scsi connector, thereby dropping what sounds like a nut and an washer into the inside of the casing. Does anyone out there know how to pull one of these cases apart? There are only two screws on the back of the drive, which look like they hold the fan in, and I doubt pulling them off would accomplish much. Any advice? Fred Dushin Syracuse University, Syracuse, NY Internet: Bitnet: fadushin@rodan.acs.syr.edu fadushin@sunrise.bitnet
denbeste@bgsuvax.UUCP (William C. DenBesten) (08/21/90)
From article <4236@rodan.acs.syr.edu>, by fadushin@rodan.acs.syr.edu (Phred Dushin): > While unscrewing the scsi cable from my LaCie 30mg Cirrus drive, > ... There are only two screws on the > back of the drive, which look like they hold the fan in, and > I doubt pulling them off would accomplish much. On the side of the drive there are 4 dark grey buttons. There is a screw behind each one that holds the case together. Remove the buttons with a small flat bladed screwdriver. -- William C. DenBesten is denbeste@bgsu.edu or denbesten@bgsuopie.bitnet