swinnea@emx.utexas.edu (J. Steven Swinnea) (02/19/91)
I was recently give an old HD40 internal drive by a friiend who upgraded to
an 80meg drive. I have a case and power supply for this but I'm not sure
how to set the SCSI id on the drive. The drive is a Seagate ST157N and has
five pairs of pens located next to the SCSI cable socket there is one jumper
installed ( on the pair nearest the connector ). I suppose that at least three
of these pairs are used to set the address (which ones?) and the other two
must be for something else (what?). Does anyone have a description of these
jumpers?
Best regards,
Steve Swinnea
Dept. Materials Sci. & Engr.
ETC 9.114
University of Texas at Austin
Austin, Texas 78712
swinnea@emx.utexas.edu