vturner@nmsu.EDU (Turner) (06/04/91)
Sorry to post this to so many groups, but I wasn't sure where to place it, and
I'm really stuck (along with NuvoTech Technical Support).
I'm running a Mac Classic with system 6.0.7, MacTCP 1.0.2 or 1.0.1 (either
one fails), NuvoLink SC 1.3.1, and Ethertalk 1.2.2 (phase I). No inits of
any consequence.
So here's the story: If I assign manually from MacTCP, all is well, and BYU
Telnet 2.3.4 comes up ok. If I assign dynamically, The mouse hangs on the
opening screen of telnet.
I've tried the interface on a MacSE also, and it fails the same way.
I can see zones, and print to printers, etc.
I have checked and rechecked the ethernet number as it appears in the
NuvoLink SC Setup application, and the entry is correct in the tables.
Other macs and PCs (one mac with an Asante card) can rarp fine on that
segment, so rarpd servers are answering the requests.
Does anyone have any suggestions?
I'd really appreciate any help anyone could give. Is anyone out there
experiencing the same problem? Or has anyone gotten this type of setup to
work with MacTCP assigning dynamically?
Any help would be greatly appreciated,
Thanks,
Vaughan
--
VaughAn Turner Internet: vturner@nmsu.edu
Networking/Workstation Support Box 30001, Dept. 3AT
Computer Center, Networking/WSC Las Cruces, New Mexico
New Mexico State University 88003-0001
Bitnet: vturner@nmsu UUCP: ucbvax!nmsu.edu!vturner
Work: (505) 646-4244 FAX: (505) 646-5278 Home: (505) 522-3653
Home Address: 1115 Larry Drive Las Cruces, New Mexico 88001-5457
"...the first rule of engineering [is] to work with Earth's natural forces,
never against them."
"Earth" by David Brin