rwmira01@ULKYVX.BITNET (Rob Miracle) (12/19/89)
I have a strange sort of question. Here is my setup:
IBM PS/2 Model 70
AIX-PS/2 1.1.0 (Updates, 1001, 1002, 1034 mostly applied :-) )
Daystar AppleTalk Card
AppleLaser II NTX
DOS Merge
I can get the printer to work find from DOS but not from DOS Merge. I was
reading through the DOS Merge book and it said something to the extent of
"If you need to change the STACKS parameter, you must first build a new
DOS image" It then went on to explain about what the heck a DOS image was.
My question is this. If I make a DOS system diskette with the proper
CONFIG.SYS with the Daystar device drivers and I make a new image will
my device driver be available to DOS Merge?
(Before any of you say, well put it in your DOS Merge Config.SYS, BZZZT Wrong
answer, it errors out when AIX/DOS Merge trys to load it because AIX doesn't
know about the card.)
Any thoughts or imaginative suggestions on this one.
Thanks in advance and please respond by e-mail, our news feed is rather flaky
these days. I'll post a followup if I get enough responses.
Rob
--
Rob Miracle | Bitnet : RWMIRA01@ULKYVX CIS: 74216,3134
Programmer/Analyst-II | INTERNET : rwmira01%ulkyvx.bitnet@cunyvm.cuny.edu
University of Louisville | UUCP : ...psuvax1!ulkyvx.bitnet!rwmira01
"It's a large building with patients, but that's not important right now."
-- Leslie Nelson from Airplane, The Movie