DICAPUA@IBACSATA.BITNET (Giancarlo Di Capua) (11/28/90)
Hello anyone, I'm installing Isode 6.0 on HP 9000/320 equipped with an HP X.25 board (CATFISH).All that I would know is whether the Transport of Isode see this kind of board. If no, is there some way to run the transport on X.25 network? How I have to install Isode to run it on X.25? Any help is useful. --------------------------------- ------------------------------ Giancarlo Di Capua tel.: +39-80-8770365 Software Factory Dept. tlx.: 810371 TECPOL I Tecnopolis - CSATA Novus Ortus fax : +39-80-651868 (G3) Strada Prov. per Casamassima Km.3 e-mail: dicapua@ibacsata.bitnet 70010 VALENZANO (BARI) ITALY
fmerino@cpd.uva.es (Francisco Merino) (11/29/90)
Hello, Giancarlo. You are probably running HPUX operating system. The config subdirectory contains the files hpux.make and hpux.h for the cconfiguration of ISODE. The default options in this files are for TCP but you can easily change it. The possible options are in the OPTIONS file in the same subdir. When you modify those files as appropiate (configuration), generation of ISODE makes a transport layer -not standard, of course- which will run on top of X-25. If the card is enabled you shouldn't have major problems after instalation. I had to change some options for my HP-9000/350 and it worked, but I had TCP, so I can't specify the options you need. It isn't difficult though. Good luck, Javier Simo and F. Merino Department of Systems Engineering University of Valladolid ---------------------