root@jdbbs.uucp (Jon Diekema) (08/05/89)
Since lightning had damaged my previous modem (an Everx Evercom 2400),
I recently upgraded to a Telebit TrailBlazer+. But, I am having trouble
trying to configure it for use with HoneyDanBer UUCP.
Could some kind soul, send me the Dailers entry for the TrailBlazer+
and/or anything else that might help me start taping the power of
this modem?
BTW, I am running Interactive's UNIX (System Vr3) version 2.0.1.
Thanks!
--
diekema@jdbbs.UUCP | Jon Diekema
..sharkey!wyn386!wybbs!jdbbs!diekema | JD's Connection (616) 669-3792
USMAIL: 7719 Park Lane | Jenison, Michigan 2400
Jenison, MI 49428 |dennis@virtech.UUCP (Dennis P. Bednar) (08/09/89)
In article <1989Aug4.201049.1391@jdbbs.uucp>, root@jdbbs.uucp (Jon Diekema) writes: > Could some kind soul, send me the Dailers entry for the TrailBlazer+ > and/or anything else that might help me start taping the power of > this modem? We use a T2500 modem here. I'm not sure how different it is from the trailblazer +, though. I have saved two profiles: Profile A: enhanced async mode for UUCP communications Profile B: enhanced async mode for cu(1) dial-out Below is the portion of our /usr/lib/uucp/Dialers file for our telebit modem: # telebit T2500 for uucp # &F = enter enhanced async mode, (load factory settings into RAM) # (this guarantees the next command can be understood) # &E1 = load Profile A from EEPROM (Profile A is for UUCP). # # Profile A was created as follows: # at&f # load enhanced factory settings into RAM # ats50=255 # pg 5-39. Fast Mode (PEP mode). # ats7=240 # pg 5-34. Seconds to wait for DCD # # ... NOTE: s7=241 stored in profile B, # # so easy to tell whats in RAM ("ats7?" to find value) # ats52=1 # pg 5-43. Modem hangs up if DTR dropped. # # ... Modem will not answer if DTR is off. # ats51=4 # pg 5-41. 9600 baud on serial line. # ats66=1 # pg 5-50. Lock interface, and use flow control. # ats111=30 # select protocol G for uucp # at131=1 # pg 5-67. DCD is ON only when carrier from remote modem # at&w1 # EEPROM.profileA = RAM (save into Profile A) # Profile B was created as follows: # at&f # ats52=4 # DTR drops => drop phone line, etc. DTR off, no answer. # ats7=241 # so I can tell which profile is in RAM # at&w2 # telebituucp =,-, "" \M\dAT&F&E1\r\c OK\r \EATDT\T\r\c CONNECT \m\c telebitcu =,-, "" \M\dAT&F&E2\r\c OK\r \EATDT\T\r\c CONNECT \m\c -- Dennis Bednar uunet!virtech!dennis (703) 430-9247 Virtual Technologies Inc, P.O. Box 876, Sterling VA, 22170