klq1921@peach.ucsb.edu (Karl L. Quackenbush) (12/10/89)
I am unable to get Interactive unix to work with an Data Technology Corporation controler. I keep getting the message "unable to open device /dev/rdsk/0p0" throughout the installation and then it just finally aborts the installation. I know there is no problem with the hard disk as it works fine with other versions of unix from other companies. I have also tried using the mapping mode on my harddisk controler to map it from 26 sectors/track to 17 sectors/track and it still does not work. Any help would be very much appreciated.
bt455s10@uhccux.uhcc.hawaii.edu (Carl "Art" McIntosh) (12/11/89)
ISC will undoubtably tell you the DTC controller "is not supported by ISC" which basically means you are SOL as far as help from ISC is concerned. I had a similar problem regarding a DTC 6820 ESDI controller and a Miniscribe 9380E drive. I have purchased a fine new Adaptec 2322 controller on ISC's advice, only to learn it was the drive at fault. Guess I'm ahead of the game anyway now, since I have a *supported controller*.