dawes@extro.ucc.su.oz.au (D H Dawes) (02/12/90)
I am trying to add a second ST506 hard disk controller to my 386 running Xenix. I can change the I/O base address and the interrupt the controller uses, but I don't know what to change them to. I have tried a few combinations, but Xenix is not recognising these. I would appreciate some help here. David Dawes Department of Theoretical Physics, University of Sydney, Australia dawes@extro.ucc.su.oz dawes@suphys.physics.su.oz
jbayer@ispi.UUCP (Jonathan Bayer) (02/12/90)
dawes@extro.ucc.su.oz.au (D H Dawes) writes: >I am trying to add a second ST506 hard disk controller to my 386 running >Xenix. I can change the I/O base address and the interrupt the controller >uses, but I don't know what to change them to. I have tried a few >combinations, but Xenix is not recognising these. I would appreciate >some help here. Base address of 0x170, interrupt = 37. You will have to do the low-level format before changing the settings, as most programs will not recognize these settings. JB -- Jonathan Bayer Intelligent Software Products, Inc. (201) 245-5922 500 Oakwood Ave. jbayer@ispi.COM Roselle Park, NJ 07204
mark@promark.UUCP (Mark J. DeFilippis) (02/14/90)
In article <1990Feb12.005307.10870@metro.ucc.su.oz.au>, dawes@extro.ucc.su.oz.au (D H Dawes) writes: > > I am trying to add a second ST506 hard disk controller to my 386 running > Xenix. You want to use port 170H. (Which is the alternate address on most every controller I have seen) You want to use pin D6, interrupt 15 on the board. (Interrupt 37 in master file) Note, First controller uses pin D7, interrupt 14. You can locate these pins by looking at the solder side of the board with the bracket to the left. From the left side near the bracket you will have 31 gold fingers and then the notch. From the notch counting to the right is D1, D2... D6, D7.. Dn. to create the nodes via mknod() for the new controller use mkdev hd 0 1 (Note: This material provided orig. by Dave Dillabough.) uunet!van-bc!dilltk!dave I also have a blip which came to me from SCO. If you want it I can make a cpy and mail it to you, or I can fax it to you if you have a fax. It details even more what I discuss briefly above. I can be reached at the tele-number in my signature. -- Mark J. DeFilippis SA @ Department of Mathematics and Computer Science Adelphi University, Garden City, NY 11530 (516) 663-1170 UUCP: philabs!sbcs!bnlux0!adelphi!markd