kwong@polyslo.CalPoly.EDU (Ka Chin Wong) (01/15/91)
Hi folks, I recently have a problem with the EPSON 500/510 driver when using an autosheet feeder. I have found that when using the autosheet feeder, the print out is off by about 1/2 inch vertically. I am sure that the paper loading is correct. In windows, I set up the printer as using Bin 1 sheet feeder. When start printer, the sheet feeder first autofeed the paper into correct position, but then it prints the first line 1/2 inch up. This problem exists in any windows applications that I have finally determined it is the problem of the driver. If I change the set up to tracter feed and manually press the autofeed button on the printer panel, the print out appears to be correct, but then I have to load a piece of paper on every page to print. Does anyone have this problem? Are there any fixes? The driver I have is dated 05/01/90 of size 49952 bytes. Is this the latest driver? If not, can someone give me a pointer where it is located (I have access to compuserve). I would greatly appreciate any suggestion. Thanks++ Rick