rays@bat.lle.rochester.edu (Ray Stewart) (04/12/91)
I am having a problem running windows 3.0 in enhanced mode using my ET4000 based super VGA card (Ultimate). Here is what happens: Everything works fine in Standard and Real modes. I can use the 1024 x 768 with 16 and 256 colors. When I try to run in enhanced mode I get this sync problem on my Nec 3D. I think the card switches to non interlaced mode for some reason. I have tried most everything. As a last resort I am going to write a program to switch the card back to interlaced mode. This I hope is not too difficult. If someone could send me a listing the relavent control locations and the bit definations I would be forever grateful. Also any info on windows video drivers would be helpful too. The card is made by LOGUS Technology (no longer exists) I have tried Miscrosoft and TSENG but the can't help (this should be won't) -- ----------------------------------------- Standard disclaimers are in full effect. Intelligent CPU! I thought they said INTEL CPU.... anonymous IBM designer.