osyjm@caesar.cs.montana.edu (Jaye Mathisen) (05/08/91)
Is it possible to use qemm5.12 with Windows 3.0a and get a little expanded
memory available on bootup? I'd like to load my PCSA software into EMS, and
then fire up windows in enhanced mode.
Something tells me this isn't doable.
Setting IngoreInstalledEMM doesn't seem to cut it either...
Please e-mail and I'll summmarize and post if demand warrants.
--
Jaye Mathisen,sysmgr 410 Roberts Hall,Dept. of Computer Science
Montana State University,Bozeman MT 59717 PHONE: (406) 994-{4780,3931} val@hp-lsd.COS.HP.COM (Val Walker) (05/10/91)
Jaye, If I understand your question correctly, the answer is YES! I am not sure why you need EMS for your application, however, after reading the QEMM386 manual and the readme file for system.ini, you should see clearly what parameters need to be set on your QEMM386.sys line and in your system.ini file. You will have to tell windows not to allocate any EMS in the area that you are using and that it is EMS. Good Luck, Val Walker Hewlett-Packard (val@hplsdor)