mramakri@oucsace.cs.OHIOU.EDU (Murlidar Ramakrishnan) (02/28/90)
Can anyone suggest me a way around for my boot up error:
It bootups perfectly if I interrupt it by command - command tilde and enter a
'b' or bsd.
But if it is left undisturbed, it comes up with SCSI error after the Loading
from disk panel . It keeps displaying these two panels one after the other and
never comes up.
Thank You
Murli Ram
mramakri@oucsace.cs.ohiou.edu
ENT0086@OUACCVMB.BITNET
rca@cs.brown.edu (Ronald C.F. Antony) (03/02/90)
try the following: after you power up the machine enter the monitor ( cmd-cmd-~ ) and then look at the boot parameters: (enter p) The system will show you several parameters and prompt you to give other values. In general you should NOT change them. Look however at, if I remember correctly, the first one. This is the bood command and should read " sd ". Also be sure that the boot extended diagnostics is set to no. Ronald ------------------------------------------------------------------------------ "The reasonable man adapts himself to the world; the unreasonable one persists in trying to adapt the world to himself. Therefore all progress depends on the unreasonable man." Bernhard Shaw | rca@cs.brown.edu or antony@browncog.bitnet